Stationary Powder-Filling Machine Model UP02

The biggest and most powerful powder-filling machine,
highly successful worldwide for more than 40 years.

 

Model UP 02-5

 

With our most efficient filling

machine you can fill directly

all powder extinguishers up

to 250 kg content.

 

With its ergonomic design it is

suitable for smaller filling series.
 

The filter cleaning is done electrically by push button and can be made easily after each filling process.

For fine cleaning a vibrator is installed at the separator.

 

Technical Data:

Performance:

approx. 14 - 19 kg/min.

Power consumption:

400 V, three-phase, 50/60 Cy

Weight:

approx. 200 kg

Dimensions:
850 x 1200 x 2700 mm

 

 

 

 

Technical Data:

 

Filling output:

UP02-5
6-kg-container

50

 pcs./h
12-kg-container

30

 pcs./h
50-kg-container

6

 pcs./h
250-kg-container

1

 pcs./h
Conveying capacity

600

 kg/h
Storage capacity

50

 kg
Filter range

1,50

 mē

Reversing

counter air

Blower type

gas ring compressor
Suction performance

max. 220

 mbar

Motor performance

1,5

kW

Operating time

100 %

ED

Electric supply

400 V, 3 Ph, 50 60 Cy
Dimension: W x D

850 x 1200

 mm
H min./max

2200 / 2700

 mm
Weight

200

 kg

Paint

White (RAL 9010)

powdercoated

 

 

 

Working position of powder refilling machine model UP02-5
 

Filling or Refilling of Extinguishers - P 12 kg

The container to be filled is placed onto the lifting table and pressed against the sealing cone of the control funnel when actuating the crank handle. To this effect the container orifice and the centre of the sealing cone have to be aligned towards each other. Then the holding magnets at the fork can be adjusted in away that further containers of same type and size are automatically aligned.

Then place the powder storing container or storing sack on to the balance if available and suction the required quantity of powder by means of the suction pipe into the extinguisher to be filled.

Filling of Mobile Extinguisher  - P 50 kg

For emptying and refilling of larger mobile extinguishing units the lifting device is swung away, and the extinguishing unit up to a size of type P 50 can be placed directly below the control funnel. After that lower the separator until the sealing cone covers the filling orifice.

Filling of Mobile Extinguisher - P 250 kg

If the mobile fire extinguishing units P 100 and P 250 are to be filled, these units we first place most closely to the filling machine. Then crank the powder separator completely upwards to maintain a fall between the connecting flange of the control funnel and the filling orifice. Replace the control funnel with the two knurled nuts by the interchangeable connecting piece (accessory).